View unanswered posts    View active topics

Board index Linux General

All times are UTC - 6 hours





Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 
Print view Previous topic   Next topic  
Author Message
Search for:
Marc.Rudolph
PostPosted: Thu Jun 01, 2006 3:14 pm 
Offline
Joined: Mon Feb 06, 2006 10:32 am
Posts: 23
Hi!

Now I'm without any idea how this can happen (and cannot find something here)

I can reach my mythtv with ping, mythweb works, vnc works etc.

But no "www" adress or grabbing or mythweb. etc. myth cannot find anything outsite

Hardware:
Router (linux "fli4l") - works since months, nothing changed, worked before with mythtv ...

Connected via switch - cable is checked (and works fine internal...)


ifconfig:
Code:
sit0      Protokoll:IPv6-nach-IPv4 
          inet Adresse:192.168.123.111  Maske:255.255.255.0
          inet6 Adresse: ::127.0.0.1/96 Gltigkeitsbereich:Unbekannt
          inet6 Adresse: ::192.168.123.111/96 Gltigkeitsbereich:Kompatibilitt
          UP RUNNING NOARP  MTU:1480  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:2 dropped:0 overruns:0 carrier:0
          Kollisionen:0 Sendewarteschlangenlnge:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)


root@mythtv:/home/mythtv# ifconfig eth0
eth0      Protokoll:Ethernet  Hardware Adresse .....snippsnapp... 
          inet Adresse:192.168.123.111  Bcast:192.168.123.255  Maske:255.255.255.0
          inet6 Adresse: fe80::240:33ff:fee2:5e3b/64 Gltigkeitsbereich:Verbindung
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:62648 errors:0 dropped:0 overruns:0 frame:0
          TX packets:118324 errors:0 dropped:0 overruns:0 carrier:0
          Kollisionen:0 Sendewarteschlangenlnge:1000
          RX bytes:3831472 (3.6 MiB)  TX bytes:176132170 (167.9 MiB)
          Interrupt:5 Basisadresse:0xe400


How can i find out what´s wrong?
Top
 Profile  
 
nickread
 Post subject:
PostPosted: Thu Jun 01, 2006 5:44 pm 
Offline
Joined: Tue Nov 22, 2005 7:57 pm
Posts: 295
Location: Auckland, New Zealand
Sounds like you're routing is messed up or you are missing a default gateway. Try 'route' from the command line - what does this say?
Your default gateway should be the ip address of your router on the 192.168.123.0 subnet - maybe 192.168.123.1?

If your myth box is getting its ip address dynamically (via dhcp) it should know this automatically. If you set it up with a static ip address you may not have configured this right?

_________________
HP VL400 (PIII 866), Skystar2 2.6D, PVR350, Nvidia FX5200, 384MB, 200GB, KnoppMyth R5.5
Top
 Profile  
 
Xsecrets
 Post subject:
PostPosted: Thu Jun 01, 2006 9:21 pm 
Offline
Joined: Mon Oct 06, 2003 10:38 am
Posts: 4978
Location: Nashville, TN
also check /etc/resolv.conf and make sure it has the correct dns entry in it.

_________________
Have a question search the forum and have a look at the KnoppMythWiki.

Xsecrets
Top
 Profile  
 
mjl
 Post subject:
PostPosted: Fri Jun 02, 2006 5:51 am 
Offline
Joined: Sun Jun 12, 2005 10:55 pm
Posts: 3161
Location: Warwick, RI
Hi,

As root, just re-run netcardconfig , use dhcp, then retry a "www", if that doesn't work repeat only select manual and put in your own information. I simply use the gateway as a dns and let it do the work.

Mike
Top
 Profile  
 
Marc.Rudolph
PostPosted: Mon Jun 05, 2006 6:22 am 
Offline
Joined: Mon Feb 06, 2006 10:32 am
Posts: 23
Thanks for your input.

This is my solution:

just
"ifconfig sit0 down"
Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 


Board index Linux General

All times are UTC - 6 hours




Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu