| LinHES Forums http://forum.linhes.org/ |
|
| network works only internal - no access to "www"/ http://forum.linhes.org/viewtopic.php?f=5&t=10308 |
Page 1 of 1 |
| Author: | Marc.Rudolph [ Thu Jun 01, 2006 3:14 pm ] |
| Post subject: | network works only internal - no access to "www"/ |
Hi! Now I'm without any idea how this can happen (and cannot find something here) I can reach my mythtv with ping, mythweb works, vnc works etc. But no "www" adress or grabbing or mythweb. etc. myth cannot find anything outsite Hardware: Router (linux "fli4l") - works since months, nothing changed, worked before with mythtv ... Connected via switch - cable is checked (and works fine internal...) ifconfig: Code: sit0 Protokoll:IPv6-nach-IPv4
inet Adresse:192.168.123.111 Maske:255.255.255.0 inet6 Adresse: ::127.0.0.1/96 Gltigkeitsbereich:Unbekannt inet6 Adresse: ::192.168.123.111/96 Gltigkeitsbereich:Kompatibilitt UP RUNNING NOARP MTU:1480 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:2 dropped:0 overruns:0 carrier:0 Kollisionen:0 Sendewarteschlangenlnge:0 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) root@mythtv:/home/mythtv# ifconfig eth0 eth0 Protokoll:Ethernet Hardware Adresse .....snippsnapp... inet Adresse:192.168.123.111 Bcast:192.168.123.255 Maske:255.255.255.0 inet6 Adresse: fe80::240:33ff:fee2:5e3b/64 Gltigkeitsbereich:Verbindung UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:62648 errors:0 dropped:0 overruns:0 frame:0 TX packets:118324 errors:0 dropped:0 overruns:0 carrier:0 Kollisionen:0 Sendewarteschlangenlnge:1000 RX bytes:3831472 (3.6 MiB) TX bytes:176132170 (167.9 MiB) Interrupt:5 Basisadresse:0xe400 How can i find out what´s wrong? |
|
| Author: | nickread [ Thu Jun 01, 2006 5:44 pm ] |
| Post subject: | |
Sounds like you're routing is messed up or you are missing a default gateway. Try 'route' from the command line - what does this say? Your default gateway should be the ip address of your router on the 192.168.123.0 subnet - maybe 192.168.123.1? If your myth box is getting its ip address dynamically (via dhcp) it should know this automatically. If you set it up with a static ip address you may not have configured this right? |
|
| Author: | Xsecrets [ Thu Jun 01, 2006 9:21 pm ] |
| Post subject: | |
also check /etc/resolv.conf and make sure it has the correct dns entry in it. |
|
| Author: | mjl [ Fri Jun 02, 2006 5:51 am ] |
| Post subject: | |
Hi, As root, just re-run netcardconfig , use dhcp, then retry a "www", if that doesn't work repeat only select manual and put in your own information. I simply use the gateway as a dns and let it do the work. Mike |
|
| Author: | Marc.Rudolph [ Mon Jun 05, 2006 6:22 am ] |
| Post subject: | Problem solved: just "ifconfig sit0 down" |
Thanks for your input. This is my solution: just "ifconfig sit0 down" |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|