G'day all,

Subject say's it all.

I have the mythtv X frontend set up OK, I can use the interface to move/size that and I have done that.

But how do I size the 'tv'? is this an X*4 config setting again? I think it is.

So bar the jitter and the size, everything seems OK!

Hi stinga,

Look under the Utilities/Setup > Setup > Tv Settings > Playback > and there should be a page (~7) where you can adjust overscan along with any offsets you may require.

It is a trial and error process

Mike

G'day mjl,

I tried that, but it only seemed to move/change the gui size, not the tv picture size..

I am using a pvr350, does that make a difference?

Stinga...