G'day all,
Thnaks for the help so far.
I tried what was suggested and the picture is still awful
In fact it did not seem to make any difference at all whatever I set it too.
Anything else I can try or infomation I can give?
| LinHES Forums http://forum.linhes.org/ |
|
| Really bad picture http://forum.linhes.org/viewtopic.php?f=5&t=6785 |
Page 1 of 1 |
| Author: | stinga [ Sat Nov 05, 2005 4:52 am ] |
| Post subject: | Really bad picture |
G'day all, New to all this and not sure where to start! I installed R5 Alpha 22 on a MSI:km4m-v with a pvr350 The picture is really grainy, you can see what is going on, but just plain awful. I have plugged a tv in to make sure the signal is good to the wall and it is. I am now stuck and don't know what to do. Is there anyway I can test at a low level to see what the problem lies? Other than that everything seems OK (other than the remote but we can get to the later!) |
|
| Author: | bube [ Sat Nov 05, 2005 4:44 pm ] |
| Post subject: | |
Did you try to change the encoding settings for your PVR 350? The bitrate should be at last 2000 kbps and the peakrate should be above 6000 kbps. You can try to change this settings manually with ivtctl during watching TV with MythTV. The syntax is something like ivtvctl -c bitrate=2000000 if I remember correctly. It should be possible to watch TV with mplayer using the command mplayer /dev/video0. |
|
| Author: | stinga [ Sun Nov 06, 2005 3:08 am ] |
| Post subject: | |
Many thanks! I will try that and get back with my results. Need to reinstall, I have mucked around with too many things now! Stinga |
|
| Author: | stinga [ Sun Nov 06, 2005 4:39 pm ] |
| Post subject: | |
G'day all, Thnaks for the help so far. I tried what was suggested and the picture is still awful
In fact it did not seem to make any difference at all whatever I set it too. Anything else I can try or infomation I can give? |
|
| Author: | mjl [ Sun Nov 06, 2005 5:24 pm ] |
| Post subject: | |
Hi, What is a Quote: MSI:km4m-v ? Certain processor speeds can cause issues with making noise, however a poor rf connection can do similar.
Mike |
|
| Author: | stinga [ Mon Nov 07, 2005 2:11 pm ] |
| Post subject: | |
OK all, I have solved this problem, it was a dud cable. Worked fine with the TV but not with the 350! I made up a new one and all the picture was realy clear. I'll start a new thread for my next problem. Many thanks. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|