| LinHES Forums http://forum.linhes.org/ |
|
| 5.1 audio on a epia m10000 http://forum.linhes.org/viewtopic.php?f=5&t=8877 |
Page 1 of 1 |
| Author: | martijnmoret [ Wed Mar 08, 2006 3:33 pm ] |
| Post subject: | 5.1 audio on a epia m10000 |
Hi, I own a M10000 with Knoppmyth and want to connect a 5.1 set to it. I am using the analogue cables but the 5.1 does not come out ( even if enabled in Xine). Do I have to alter some config setting (outside of Xine of Mplayer)? Does someone have got it work with the analogue cables or should I go for S/PDIF? Any howto's for this linux non-expert? Greets, Martijn |
|
| Author: | willem [ Fri Mar 10, 2006 2:23 am ] |
| Post subject: | |
There is a jumper that lets you select whether you want to use the RCA connector for TV-out or S/PDIF. I tried a M10000 once and the jumper settings where exactly opposite to what the manual said! So setting the jumper to TV-out (according to the manual) gave me AC3 pass through. It took me some time to figure that out... |
|
| Author: | martijnmoret [ Sat Mar 11, 2006 3:47 am ] |
| Post subject: | |
hmmm, I've been playing with that thought.... I used the RCA port for video playback, but upon opening the case, the jump was in SP/DIF mode.... OK, i'll open up again. Thanks! |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|