I have a WinTv Go Plus and no matter what I tried I am getting a green screen.

I had been working until I installed updated nVidia drivers and change the display setting.

I have the line "options bttv card=10 tuner=39" in the KnoppMyth file.

I also reinstalled the entire KnoppMyth CD and still the same thing. Doesn't work.

Does anyone have any ideas how to fix this, I am getting frustrated and not sure what to do.

You may want to go back and delete the other one. Use the [X] in the upper right hand corner (following [Quote] and [Edit]) of your posting there.

This is my output for dmesg, I hope someone can help me.

root@mythtv:~# dmesg | grep bttv
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:02:09.0, irq: 18, latency: 64, mmio: 0xf8001000
bttv0: using: Hauppauge (bt878) [card=10,insmod option]
bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
bttv0: Hauppauge eeprom indicates model#0
bttv0: using tuner=39
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: PLL can sleep, using XTAL (28636363).

I just want to know if I should post any more information to help diagnose this problem, in addition did I post this under the correct location.

Some more information

So half the time when I restart the computer and when you do dmesg the line below reads #0 and the other half it is as it reads.

Hauppauge eeprom indicates model#44981

And if the line reads as displayed I get a green screen when I try to watch TV and when I do dmesg I get the message below.

tuner 1-0061: i2c i/o error: rc == -121 (should be 4)