I've not seen any of your posts here, so without asking for help on particular points, it's very difficult to answer your questions.
Quote:
But alas, i give up, i am forced to fill in a postcode during the configuration (after i found out that a terminal screen was waiting with ALT-TAB while i was waiting what for progress after mythsetup part 4
You need to select the correct grabber for your country, the default is just that, the default. I use for the UK one (tv_grab_uk_rt). Though you haven't described your current config, if you are using DVB-T you can use the EIT grabber so get your EPG information from your TV signal.Quote:
NO /root/.lircrc /etc/lircrc (don't exist !!)
Of course not, the MythTV user is not root. The lirc information is held under /etc/lirc and /home/mythtv/.mythtv/ .Quote:
Mythweather forces me to fill a postcode (only it shows US etc) and as a result my europe zip code results in error (and no way to change it in the setup !!!!!!!!!!)
It not clear what is required for non US users, you either put in a US post code or the weather station location information, in my case it is :UKXX0045. You should be able to Press Enter at the prompt and in the front end application use Setup/Utilities->Setup->Info Center Settings ->Weather Settings to correct this. If you have entered faulty data it can mean the weather application tries to fetch data about a non existant location, this can be fixed as follows:Open up a console and type the following:
Code:
cat /usr/share/mythtv/mythweather/accid.dat |grep location
where location is where you live, perhaps using the nearest town or city. Then use the information posted hereQuote:
No working remote (silver) while i choose it anyway during setup
If you are using a DVB-T card you need to use a different setup something like this.
Bruce S.