LinHES Forums
http://forum.linhes.org/

Issue with automountig USB mass storage...
http://forum.linhes.org/viewtopic.php?f=6&t=14784		 Page 1 of 1
Author:  Warped [ Sun Apr 01, 2007 4:43 am ]
Post subject:  Issue with automountig USB mass storage...
Hi *

I have following problem with automounting USB mass storage in r5e50:
-when I insert 1G USB FAT32 formated pen drive - myth correctly pops up with dir.browser and I can easily access content.
-attaching ext HDD (ext.USB case with PATA-USB converter) - r5e50 detects drive, but no dir browser pops up.

Here is log when USB pen drive is attached:

----------------------------------------------------
Apr 1 12:26:07 mythtv kernel: usb 3-2: new full speed USB device using uhci_hcd and address 3
Apr 1 12:26:07 mythtv kernel: usb 3-2: configuration #1 chosen from 1 choice
Apr 1 12:26:07 mythtv kernel: scsi1 : SCSI emulation for USB Mass Storage devices
Apr 1 12:26:12 mythtv kernel: Vendor: ChipsBnk Model: Flash Disk Rev: 2.00
Apr 1 12:26:12 mythtv kernel: Type: Direct-Access ANSI SCSI revision: 02
Apr 1 12:26:12 mythtv kernel: SCSI device sdb: 2068224 512-byte hdwr sectors (1059 MB)
Apr 1 12:26:12 mythtv kernel: sdb: Write Protect is off
Apr 1 12:26:12 mythtv kernel: SCSI device sdb: 2068224 512-byte hdwr sectors (1059 MB)
Apr 1 12:26:12 mythtv kernel: sdb: Write Protect is off
Apr 1 12:26:12 mythtv kernel: sdb: sdb1
Apr 1 12:26:12 mythtv kernel: sd 1:0:0:0: Attached scsi removable disk sdb
Apr 1 12:26:12 mythtv kernel: UDF-fs: No VRS found
Apr 1 12:26:13 mythtv kernel: Unable to identify CD-ROM format.
Apr 1 12:26:25 mythtv kernel: usb 3-2: USB disconnect, address 3
Apr 1 12:26:25 mythtv kernel: lost page write due to I/O error on sdb1
------------------------------------------------------


And here is log when USB HDD is attached:
------------------------------------------------------
Apr 1 12:30:41 mythtv kernel: usb 5-6: new high speed USB device using ehci_hcd and address 5
Apr 1 12:30:41 mythtv kernel: usb 5-6: configuration #1 chosen from 1 choice
Apr 1 12:30:41 mythtv kernel: scsi2 : SCSI emulation for USB Mass Storage devices
Apr 1 12:30:46 mythtv kernel: Vendor: SAMSUNG Model: SP2514N Rev: VF10
Apr 1 12:30:46 mythtv kernel: Type: Direct-Access ANSI SCSI revision: 00
Apr 1 12:30:46 mythtv kernel: SCSI device sdb: 488397168 512-byte hdwr sectors (250059 MB)
Apr 1 12:30:46 mythtv kernel: sdb: Write Protect is off
Apr 1 12:30:46 mythtv kernel: SCSI device sdb: 488397168 512-byte hdwr sectors (250059 MB)
Apr 1 12:30:46 mythtv kernel: sdb: Write Protect is off
Apr 1 12:30:46 mythtv kernel: sdb: sdb1
Apr 1 12:30:46 mythtv kernel: sd 2:0:0:0: Attached scsi disk sdb
-----------------------------------------------------

Of course I can manually mount USB HDD, but I want to achieve config where r5e50 does it automatically...


Is this problem related to udev, or other r5e50 component ?

thx in advance !
Author:  bruce_s01 [ Sun Apr 01, 2007 8:02 am ]
Post subject: 
The obvious question is, has the USB drive been partitioned and formatted?

Bruce S.
Author:  Warped [ Sun Apr 01, 2007 10:58 am ]
Post subject: 
Well,

Of course I can manually mount USB HDD, but I want to achieve config where r5e50 does it automatically...




bruce_s01 wrote:
The obvious question is, has the USB drive been partitioned and formatted?

Bruce S.
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/