| LinHES Forums http://forum.linhes.org/ |
|
| EIT - Shows now and next only http://forum.linhes.org/viewtopic.php?f=6&t=15279 |
Page 1 of 1 |
| Author: | jimyhunt [ Sat May 19, 2007 9:38 am ] |
| Post subject: | EIT - Shows now and next only |
Just upgraded to R5F1. Enabled EIT to get the tv data over the air. But it is only getting the current program and the next. How do i get all the rest of the program information? Note: I am in the UK Thanks Jim |
|
| Author: | simonf [ Sat May 19, 2007 1:42 pm ] |
| Post subject: | EIT UK DVB |
jim If You are using UK DVB-t ?? I get all the data, i have set a signal source up for EIT data only and have attached both tuners to this source in the set up. It does take a while to get all the data the first time you set it up. Simon F |
|
| Author: | jimyhunt [ Sun May 20, 2007 3:43 am ] |
| Post subject: | |
Thanks for the reply. How did you set up a EIT channel? I now have got all the info. It took its time. It normally doesnt take that long to get all the channel data. |
|
| Author: | simonf [ Sun May 20, 2007 6:22 am ] |
| Post subject: | |
Jim, Its an Off air guide only video source I used Intead of UK Channel Guide. Think its called Video sources Item 3 on the menu I think select eit data only then associate that source with your tuner card(s). I figure youve probably done this anyhow if your geting the data now SimonF |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|