| LinHES Forums http://forum.linhes.org/ |
|
| R5F27 slave backend tuner lockout http://forum.linhes.org/viewtopic.php?f=6&t=17940 |
Page 1 of 1 |
| Author: | aazaroff [ Sat Feb 23, 2008 2:10 pm ] |
| Post subject: | R5F27 slave backend tuner lockout |
I have already searched on many combination of the various terms relating to this and have found nothing usefull. I currently inherited 2 digital tuner cards from a friend who has decided to go to appletv. A Dvico fusion 5 lite and a pchdtv. When I got these cards I decided to upgrade my systems to r5f27. My previous configuration: sys1 - MBE+FE sys2 - FE only sys3 - FE only My current config (same hardware sys1 - MBE+FE sys2 - SBE+FE sys3 - FE only I did not have any slots left in my MBE (has 3 analog tuners already) so I converted one of my FE to a SBE+FE. Everything works fine except that the MBE thinks the two new tuners are always in use. I get the "MythTv is already using all available inputs for the channel you selected" message. I can view any of the tv channels from the analog tuners in the MBE but not any of the digital tuners in the SBE. I looked in the inuseprograms table and there is no active job running for any of tuners on the SBE. I am at a loss as to where else to look to release this lock. Rebooting both the backend machines does nothing. I know the tuners work because when I pull the network on the SBE and reconfigure it (change the IPs to loopback and bring up mysql) to be the MBE I can watch both the digital tuners and have found 5 hd and about 20 sd clear QAM channels on my cable and would like to be able to watch them as I have 2 HDTVs. Thanks Andre. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|