Just wondering if anyone has sound working in FCEU under R5.5

I'm using the digital out on my AV710 and haven't been able to get any sound out of the program. Any ideas? When run in a window it doesn't show any errors, which makes me think it's using the analog out instead of digital. Could this be fixed with an asound.conf entry?

Searching the internet hasn't been too fruitful, although one post suggested using a sound wrapper, but I know I had it working at some point without that.

_________________
MBE:AMD Athlon 64 3000+ (venice),MSI K8MM-v Motherboard (via chip based), PVR-500, Chaintech av710, IDE Hard drive
SBE:P4 3Ghz, Asus P4G800, PVR-250, IDE Hard Drive

Still looking for a solution. I know the sound works fine on my sbe that uses simple analogue out, so that would suggest that the digital out on my mbe is the problem.

_________________
MBE:AMD Athlon 64 3000+ (venice),MSI K8MM-v Motherboard (via chip based), PVR-500, Chaintech av710, IDE Hard drive
SBE:P4 3Ghz, Asus P4G800, PVR-250, IDE Hard Drive

for thos also having this issue, you can use the aoss wrapper to get it to work. For me it was as simple as changing the command line to

_________________
MBE:AMD Athlon 64 3000+ (venice),MSI K8MM-v Motherboard (via chip based), PVR-500, Chaintech av710, IDE Hard drive
SBE:P4 3Ghz, Asus P4G800, PVR-250, IDE Hard Drive