LinHES Forums http://forum.linhes.org/ |
|
Getting remote working again under R6 http://forum.linhes.org/viewtopic.php?f=6&t=20633 |
Page 2 of 2 |
Author: | christ [ Sat Jan 30, 2010 6:50 pm ] |
Post subject: | |
ah ok. I am surprised that driver outputs codes at that level but given yours works then it would seem to be ok. |
Author: | mihanson [ Sun Jan 31, 2010 9:54 am ] |
Post subject: | |
Greg Frost wrote: mihanson: what is the command line for lircd?
It's lircd1 because when I boot up my lircd starts my working serial ir receiver. I stop lircd, rmmod lirc_serial and restart lircd by hand using the same command you have, but lirc1 instead of lirc0 for the GP-IR02BK. |
Author: | marc.aronson [ Tue Oct 11, 2011 1:11 am ] |
Post subject: | |
I am attempting to get a GP-IR02BK remote working, without success. I've started a new thread for this issue, located here. I'm posting a cross-reference here as I am hoping that someone on this thread can help me figure this out. Thanks! |
Page 2 of 2 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |