LinHES Forums
http://forum.linhes.org/

No PIDS set
http://forum.linhes.org/viewtopic.php?f=6&t=3997		 Page 1 of 1
Author:  superkrusty [ Tue Mar 29, 2005 8:24 am ]
Post subject:  No PIDS set
Hi Guys,

Visionplus card set and seems o.k Myth log now reports No PIDS set, please correct your channel $.

Anyone know the PIDS for Melbourne ?

Cheers

Brad



2005-03-29 23:41:55.447 DVB#0 Recorder: Card opened successfully (using PS mode$
2005-03-29 23:41:55.450 DVB#0 ERROR - No PIDS set, please correct your channel $
2005-03-29 23:41:56.453 DVB#0 WARNING - No data from card in 1 second.
Author:  Jaelson [ Tue Mar 29, 2005 11:54 am ]
Post subject: 
. Close Mythfrontend (CTRL + ALT + BACKSPACE);
. ALT + S FOR FAILSAFE TERMINAL;
. Run mythtv-setup in terminal;
. ENTER (Leave ...);
. ENTER (Leave ...);
. Choose Input Source and select one;
. Set Start Channel (1, 2, 3, ...);
. Choose Channel Editor;
. Choose Advanced;
. Add one transport;
. ESC, ESC;
. Select Scan DVB Channel;
. Selecto Scan Transport created;
. ENTER, ENTER;
. Good Luck.

Jaelson Lima
Brasil
Author:  nigelpearson [ Wed Mar 30, 2005 6:34 am ]
Post subject: 
Hola! Jaelson
Good description of how to scan. I suspect the problem is something simpler, though.

Brad, two thoughts:
1) After scanning, did you set channel numbers in the Channel Editor?
I don't think MythTV copes if there are none.
2) Does the start channel exist?
I think the default start channel for each card (in the Card Inputs settings) is 3. This is the channel that the backend tries to tune to when you first "Watch TV", and if it doesn't match a number defined in the channel editor, then you will get the PID errors (the message that the backend reports should be improved).

I know I have made both of these mistakes before.
Author:  Jaelson [ Thu Mar 31, 2005 8:02 am ]
Post subject: 
Hi,

1. Scanning is automatic but you will need to adjust channel number in Channel Editor.

2. Start Channel is in "Input Conection".

Visit http://www.digitalregime.com/mythdvb/setup/ for details.


superkrusty's Start channel config is NULL (vide "please correct your channel $" message) and need to be set for 1 or 2 or 3 ... in Input Conection Option.

My DVB-s (Skystar 2 Rev. 2.6c) in Mythtv is good. I´m in Brasilsat B1 Satellite and my PIP show local analogue channels (Hauppage WinTV).


Jaelson Lima
Brasil
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/