LinHES Forums
http://forum.linhes.org/

Need to switch video input on pvr-350!!
http://forum.linhes.org/viewtopic.php?f=6&t=6313		 Page 1 of 1
Author:  crackler [ Wed Oct 05, 2005 8:48 am ]
Post subject:  Need to switch video input on pvr-350!!
Just a quick question. How would I go about changing which input on my pvr-350 mythtv records on? I would think that there is a config file to do this, or that there should be a place in the Mythtv interface I could change this (can't find one so far).

I just don't want to have to reformat and go throught the whole setup again when all I need to do is switch the video input from s-video1 to s-video0.

Thanks to any reply. 8)
Author:  cesman [ Wed Oct 05, 2005 11:48 am ]
Post subject: 
Fire up your browser and point it to the IP of your backend. Click on MythTV keys.
Author:  ryanpatterson [ Wed Oct 05, 2005 3:19 pm ]
Post subject: 
I think you just need to run mythsetup agian (or is it mythtvsetup?)

Exit out of the frontend. Open an xterm <alt><x>. Type in mythsetup<enter>. The setup program you used the very first time you booted knoppmyth will start. Change the channel==>inputs assigments there. Change your current input to 'not connected' (or whatever). And set the input you want to use to your channel lineup.

Sorry if I used non standard names for a few things I'm going on memory only. But I think you should get the idea.
Author:  Xsecrets [ Wed Oct 05, 2005 3:30 pm ]
Post subject: 
actually if you are out of the mythfrontend you can just do <alt><s> and it will open up mythtv-setup so you don't have to remember the command.
Author:  crackler [ Wed Oct 05, 2005 4:15 pm ]
Post subject: 
Thanks for you input everyone, i'll give some of those things a try!
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/