Good work guys! I have updated with mostly no problems. I use an old Gforce2 card using TV out only and I did have to use a monitor after upgrade and redo the xconfig file to get my TV back. Using an pvr i50 MCE. The new firmware and drivers are great. The "wiggly lines at the top 2 pixel wide horizontal of pic is gone! The blue line is gone! Mythweb is faster...streaming works out of the box to my Windowz machine. Only glitch I have now is I dont have any data from Zp2it. Shows connect and "progress bar" goes about 3/4 of the way. Gives me the proper end of subscription date message 3/06 .I run mythfilldatabase and all seems to go well. I am getting "no data" on mythweb" and wen I go to check the program schedules from the front end it bounces me back to the desktop and I have to restart mythtv. Any Ideas? and thanks again for a great project. (mythburn just did a dvd burn from myth web..ya!)

_________________
1.7 p4 intel mb on board sound and nic
512 ram
64 meg gforce2 using TV out
PVR 150 MCE
Sony DVD burner
80 gig maxtor
Knoppmyth R5A?

Mythstream works for you? I did the same upgrade but am having no luck with Mythstream have tried a reinstall no luck either. Did you make any changes at all.

It works if I click on the mms://mythtv:8001 link on the mythweb stream page with my windows machine running firefox with vlc plugin installed. I had previously had vlc installed on 16 before the upgrade. VLC is no longer available in the gnome desktop now..but it does work thru Mythweb.

Whoa! just check mythweb to get the correct URL for this post and noticed the program guide is there and no longer says No data! I putty'd into the mythbox and ran mythfilldatabase and went to watch movie with putty session open...guess I wasnt waiting long enuff for data base operation to finish. Getting old and impatient i guess

_________________
1.7 p4 intel mb on board sound and nic
512 ram
64 meg gforce2 using TV out
PVR 150 MCE
Sony DVD burner
80 gig maxtor
Knoppmyth R5A?