| LinHES Forums http://forum.linhes.org/ |
|
| R5A30.1 - Mach Speed Matrix P4M800, WinFast TV2000, GfMX4000 http://forum.linhes.org/viewtopic.php?f=9&t=8070 |
Page 1 of 1 |
| Author: | Fray [ Tue Jan 24, 2006 10:48 am ] |
| Post subject: | R5A30.1 - Mach Speed Matrix P4M800, WinFast TV2000, GfMX4000 |
Mach Speed Matrix P4M800 Via Socket 478 Leadtek WinFast TV2000 XP RM Intel Celeron D 340 2.93GHz 512MB Ram 250GB EIDE Hard Drive eVGA Nvidia Geforce MX4000 64MB DDR Video Card with S-Video Out Capture card was detected correctly but the tuner was not. It detected as tuner=4 Based on this Wiki doc: http://www.knoppmythwiki.org/index.php? ... V2000XPdlx I changed the tuner to tuner = 43 and that got my tuner working! That Motherboard does not have an audio in header on the board so I ended up plugging the audio cable from the capture card to the CD in on the Motherboard. Right off the bat I was getting sound 2 seconds ahead of the video. Did some digging around and found what I needed to do at: http://www.mythtv.org/docs/mythtv-HOWTO-7.html#ss7.2 I tried the command line stuff first but couldn't get it working. I then used "alsamixer -V all" and set the correct settings there and that got it working. I had to enable the CD in to be captured and mute it as well as set the other settings as documented. I also found that the audio was coming through a bit garbled and had to turn the CD volume down to about 45% to clear it up. Next task was to get the remote working. The card I got came with the Y0400052 remote. Google helped me find this site: http://www4.tpg.com.au/undy/mythtv/mythtv.htm He used the same capture card as me so I grabbed the lircrc and lircd.conf he used and that got my remote working. I did have to add the tab key to lircrc for use in "Import CD." Tab isn't supported natively so I had to use irxevent. http://mysettopbox.tv/phpBB2/viewtopic.php?t=4591 Next was getting it to play on my TV. My video card has S-Video out and I had not plugged it into my TV until this point. It might have detected my TV on install and got that working right off the bat had I plugged it in during install. So once again it was back to the wiki. http://www.knoppmythwiki.org/index.php? ... Transition Using that and the sample nvida config file got me up and working fairly painlessly. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|