Hi is there a wlan0 script that I can rerun I updated my kernel and now my wifi network is not working giving me a error that it is unknown device.... but I compiled the kernel from my old .config.... please help im almost done having this in my living room.....

is there a driver script I can rerun?


its a USB netgear MA111

most likely you were using one of the drivers that is not included in the stock kernel. Cesman tries to make things easy on people and thus has included three or four additional drivers with knoppmyth that do not come in the stock linux kernel. you'll have to find out what driver your card uses and recompile the driver for your new kernel.

_________________
Have a question search the forum and have a look at the KnoppMythWiki.

Xsecrets

The thing was when I first installed knoppix mythtv my onboard network card was working and also my usb netgear MA111.... the reason why I had to update the kernel cause my PC was locking up with the twinhan....

and I did copy my .config file and just remove laptop support and compile for amd Athlon
I tried to run apt-get install wlan-linux-ng but same thing reboot and says unknown device sit0....

so your saying there is no way to install the module unless I rebuild the kernel again?

no I'm saying you have to recompile the kernel module you don't have to recompile the whole kernel. besides linux-wlan-ng is just the programs what you'll need is the modules source so you can compile them.

_________________
Have a question search the forum and have a look at the KnoppMythWiki.

Xsecrets

ok this is what I did

wget ftp://ftp.linux-wlan.org/pub/linux-wlan ... e25.tar.gz

untar
and then goto folder
make config
make all
and get this error message

/bin/sh: ngcc: comand not found error 127
try to point to the kernel and dont know if im pointing to the right module directoy?
linux source directory [/usr/src/linux2.6.11.12]
module install directory [lib/modules/2.6.11.12]