Hey guys - thanks alot for all of the information I've already gathered today. My board and case are on their way right now, so I'm trying to figure out ahead of time what all I'll need to deal with once they're here.

Knoppmyth seems great, and I'm hoping I can get it working. I see from everything I've read that it's difficult (Though possible) to get this combination of hardware working. My question, though, is whether the 350 is so bitchy because of the tv-out?

The m10000 has onboard tvout, which I'd rather use anyway so that I can view the internet and divx movies as well, so I'm not planning on using the 350's tv out unless I really want to watch something in higher quality. So my question is, if I want to set up this system and not worry about tv-out on the 350, what's the story?

I've kind of seen this question asked in passing on other threads, but I haven't found any threads devoted to the question, and I couldn't find any answers to the questions that were asked... at least none that were very helpful

I've seen the epiamotherboards wiki page, and I'm betting that'll have most of my answers in it once I actually get started, but just hoping for some advice if anyone has any.

Thanks
George

The 350 capture may work right out of the box so to speak, but if you are buying it new you are probably goign to need to change the tuner setting, and maybe recompile to get a new tuner.

Use the first few steps here to get the 350 input working, then move to the M10k wiki to get TV out working. Or just finish and get tv-out working on the 350. It's really not that bad. Just build and install a driver then rebuild the frame buffers. Kinda.

http://mysettopbox.tv/phpBB2/viewtopic. ... ht=pvr+350

And yes, the hard part of a 350 is the TV-out from everything I ahve read on these boards, and my own personally week long install of the 350 with tv-out.

http://mysettopbox.tv/phpBB2/viewtopic. ... highlight=

-Lane