Hi Everyone

I have a knoppmyth R5A22 install with a pvr150mce analog card and a Dvico Fusion DVB-T Plus digital card. I sucessfully run mythtv-setup (I set up the digital card first, then the analog) and I can only view Digital TV. mythfrontend ignores my attempts to change to an analog channel number. The analog channels are visible. I have tested the pvr150mce card, and it is working properly.

I also have deleted my card and channel settings and just installed the analog card: viewing TV worked with it fine. I then configured my digital card, but its channels were being ignored.

It seems as if my knoppmyth installation will only view the first card that I configure.

Does anyone know what I'm doing wrong?

TIA

You need to press 'Y' to switch to the other card. This shouldn't be an issue w/ 0.19.

_________________
cesman

When the source is open, the possibilities are endless!

Thanks cesman

I didn't pick that up in the mythtv documentation "Keyboard commands" page. I'll try that today when I get a chance.

Cesman said



Are you implying (oh please be implying!) that 0.19 will automatically switch tuners to view the desired channel?

Having to switch tuners is the cause of a LARGE amount of grief from my wife. If 0.19 auto-switches, I can finally watch TV in peace!!

I didn't think I was implying... As the current SVN does this, so should 0.19.

_________________
cesman

When the source is open, the possibilities are endless!