I have R5D1 installed and working. I have an IRblaster connected to the built-in serial port and it was working fine controlling my DISH Network receiver.

I added a PCI serial card so I could add a serial remote receiver. According to lspci, the new card is at 0x9000 and IRQ 21.

I used setserial to set the built-in port to /dev/ttyS0 and the PCI card to /dev/ttyS1. I am stuck trying to figure out how to tell LIRC where the irblaster and receiver are located. I ran the LIRC setup and IRblaster setup script but I am sure there is more to it than that.

My question is, is there any way to have LIRC work with both serial ports using the LIRC install that is already in KnoppMyth, or should I focus my efforts on figuring out how to compile two instances of LIRC?