View unanswered posts    View active topics

Board index Linux Installation

All times are UTC - 6 hours





Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 
Print view Previous topic   Next topic  
Author Message
Search for:
okeedokee
 Post subject: PVR150 Static with R5D1
PostPosted: Tue Dec 26, 2006 12:30 am 
Offline
Joined: Fri Jun 16, 2006 6:51 am
Posts: 5
Hello,

I just Auto Installed R5D1 with a PVR-150 and get nothing but static for live TV. My card type was detected as TCL M2523_5N_E so I've added "options ivtv tuner=50" to /etc/modprobe.conf. Still no luck.

Any ideas?

Thanks
Top
 Profile  
 
okeedokee
 Post subject: Compile IVTV
PostPosted: Tue Dec 26, 2006 10:40 am 
Offline
Joined: Fri Jun 16, 2006 6:51 am
Posts: 5
I also tried compiling IVTV 0.7.2 and 0.7.3.

0.7.2 caused too many problems so I re-ran auto install.

With 0.7.3 the snow looks different, but all channels still show snow.

Thanks
Top
 Profile  
 
tjc
 Post subject:
PostPosted: Tue Dec 26, 2006 9:52 pm 
Offline
Joined: Thu Mar 25, 2004 11:00 am
Posts: 9551
Location: Arlington, MA
Did you reboot (or reload the modules) after making that change?

Did you you check your frequency set and the rest of the suggestions covered on the http://www.knoppmythwiki.org/index.php? ... WatchingTV page?

Extract the IVTV log section(s) as described on the http://www.knoppmythwiki.org/index.php? ... ngLogFiles page and post them here.
Top
 Profile  
 
okeedokee
 Post subject: Update
PostPosted: Wed Dec 27, 2006 5:22 pm 
Offline
Joined: Fri Jun 16, 2006 6:51 am
Posts: 5
I did reboot between changes and have tried everything on the BlackScreenWatchingTV page except for dealing with logs.

Here is the IVTV log info:

Thanks

Code:
Dec 26 01:36:05 mythtv kernel: ivtv:  ==================== START INIT IVTV ====================
Dec 26 01:36:05 mythtv kernel: ivtv:  version 0.7.0 (tagged release) loading
Dec 26 01:36:05 mythtv kernel: ivtv:  Linux version: 2.6.17-chw-8 SMP preempt mod_unload 586 gcc-3.4
Dec 26 01:36:05 mythtv kernel: ivtv:  In case of problems please include the debug info between
Dec 26 01:36:05 mythtv kernel: ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
Dec 26 01:36:05 mythtv kernel: ivtv:  any module options, when mailing the ivtv-users mailinglist.
Dec 26 01:36:05 mythtv kernel: ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
Dec 26 01:36:05 mythtv kernel: ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 19 (level, low) -> IRQ 19
Dec 26 01:36:05 mythtv kernel: ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
Dec 26 01:36:05 mythtv kernel: tveeprom 0-0050: Huh, no eeprom present (err=-121)?
Dec 26 01:36:05 mythtv kernel: tveeprom 0-0050: Encountered bad packet header [48]. Corrupt or not a Hauppauge eeprom.
Dec 26 01:36:05 mythtv kernel: ivtv0: No tuner detected, default to NTSC
Dec 26 01:36:06 mythtv kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
Dec 26 01:36:06 mythtv kernel: ivtv0: Encoder revision: 0x02050032
Dec 26 01:36:06 mythtv kernel: ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
Dec 26 01:36:06 mythtv kernel: ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
Dec 26 01:36:06 mythtv kernel: ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
Dec 26 01:36:06 mythtv kernel: ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
Dec 26 01:36:06 mythtv kernel: ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
Dec 26 01:36:06 mythtv kernel: ivtv:  ====================  END INIT IVTV  ====================
Dec 26 01:36:06 mythtv pci.agent[4294]:      ivtv: loaded successfully
Dec 26 01:36:10 mythtv usb.agent[4460]:      usbhid: already loaded
Dec 26 01:37:00 mythtv kernel: ACPI: PCI interrupt for device 0000:02:01.0 disabled
Dec 26 01:37:00 mythtv kernel: ivtv0: Removed Hauppauge WinTV PVR-150, card #0
Dec 26 01:37:00 mythtv kernel: ivtv:  ==================== START INIT IVTV ====================
Dec 26 01:37:00 mythtv kernel: ivtv:  version 0.7.0 (tagged release) loading
Dec 26 01:37:00 mythtv kernel: ivtv:  Linux version: 2.6.17-chw-8 SMP preempt mod_unload 586 gcc-3.4
Dec 26 01:37:00 mythtv kernel: ivtv:  In case of problems please include the debug info between
Dec 26 01:37:00 mythtv kernel: ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
Dec 26 01:37:00 mythtv kernel: ivtv:  any module options, when mailing the ivtv-users mailinglist.
Dec 26 01:37:00 mythtv kernel: ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
Dec 26 01:37:00 mythtv kernel: ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 19 (level, low) -> IRQ 19
Dec 26 01:37:01 mythtv kernel: tveeprom 0-0050: Huh, no eeprom present (err=-121)?
Dec 26 01:37:01 mythtv kernel: tveeprom 0-0050: Encountered bad packet header [48]. Corrupt or not a Hauppauge eeprom.
Dec 26 01:37:01 mythtv kernel: ivtv0: No tuner detected, default to NTSC
Dec 26 01:37:01 mythtv kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
Dec 26 01:37:01 mythtv kernel: ivtv0: Encoder revision: 0x02050032
Dec 26 01:37:01 mythtv kernel: ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
Dec 26 01:37:01 mythtv kernel: ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
Dec 26 01:37:01 mythtv kernel: ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
Dec 26 01:37:02 mythtv kernel: ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
Dec 26 01:37:02 mythtv kernel: ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
Dec 26 01:37:02 mythtv kernel: ivtv:  ====================  END INIT IVTV  ====================
Top
 Profile  
 
tjc
 Post subject: Re: Update
PostPosted: Wed Dec 27, 2006 6:04 pm 
Offline
Joined: Thu Mar 25, 2004 11:00 am
Posts: 9551
Location: Arlington, MA
okeedokee wrote:
Code:
Dec 26 01:36:05 mythtv kernel: tveeprom 0-0050: Huh, no eeprom present (err=-121)?
Dec 26 01:36:05 mythtv kernel: tveeprom 0-0050: Encountered bad packet header [48]. Corrupt or not a Hauppauge eeprom.
Dec 26 01:36:05 mythtv kernel: ivtv0: No tuner detected, default to NTSC

There is your basic problem. I think you've got a bad card. Try googling for those messages, or searching the ivtv mailing list archives: http://www.gossamer-threads.com/lists/ivtv/

Just on the off chance that it's something transient, shut the machine down cold, (unplug it), open the case, remove the card and inspect the PCI slot for foreign materials, inspect the card for any physical damage or foreign material, then reinstall the card, and reboot. If you're using a riser card or the like double check that as well. Trying a different PCI slot might also help.
Top
 Profile  
 
okeedokee
 Post subject:
PostPosted: Wed Dec 27, 2006 6:08 pm 
Offline
Joined: Fri Jun 16, 2006 6:51 am
Posts: 5
Dang. It's a brand new card. I hope it's not bad.

I also got a brand new 250 today, so I am going to give that one a shot.

Thanks
Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 


Board index Linux Installation

All times are UTC - 6 hours




Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu