Can anyone tell me how Mythwelcome decides if it's been woken up automatically or by the user??

I'm using ACPI wakeup which I have working nicely... only rather than Mythwelcome being displayed and so subsequently shutting down again when the recording has finished, it goes straight to Myth Frontend.

Any ideas?

_________________
Knoppmyth: R5F27
CASE: Silverstone LC11-M
MB: ASUS M2NPV-VM
DTV: Hauppauge WinTV Nova-T-500
FORMAT: PAL (UK)
RAM: 1GB
HDD: 400GB Samsung Spinpoint 401
TV: Samsung LE32R74BDX (via Component)

Did you have a look at http://knoppmythwiki.org/index.php?page=WakeupToRecordWithMythWelcome

There is one section that mentions making a change to use mythwelcome as the default startup:

_________________
LinHES Release 6.04.00
Mboard MSI PM8PM-V P4M800
CPU - Intel Celeron D 336 Processor 2.80GHZ
Memo - Corsair VS512MB533D2 512MB DDR2-533
Hard D - Hitachi T7K500 250GB Serial ATA
Wireless - Netgear wg311
Tuner Card - PVR-150

Yes, did that.

I've used nvram-wakeup before (on another MB) successfully, but couldn't get it working with this one so tried ACPI instead.

But it seems that mythwelcome isn't detecting that it's been woken up by ACPI successfully.

_________________
Knoppmyth: R5F27
CASE: Silverstone LC11-M
MB: ASUS M2NPV-VM
DTV: Hauppauge WinTV Nova-T-500
FORMAT: PAL (UK)
RAM: 1GB
HDD: 400GB Samsung Spinpoint 401
TV: Samsung LE32R74BDX (via Component)

When I was attempting to get mine going (gave up due to the wake up time being misconstrued upon shutdown) after making that change anytime I turned the system on it would go to the welcome screen, I had to navigate from that point to get the front end.

_________________
LinHES Release 6.04.00
Mboard MSI PM8PM-V P4M800
CPU - Intel Celeron D 336 Processor 2.80GHZ
Memo - Corsair VS512MB533D2 512MB DDR2-533
Hard D - Hitachi T7K500 250GB Serial ATA
Wireless - Netgear wg311
Tuner Card - PVR-150